Salter
False Low Water Detection
Ice maker stops and 'Add Water' light is on even though reservoir is full (no code shown)
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck float switch, Dirty water level sensor, Air bubble around sensor, Faulty water level sensor wiring
How to Fix / Troubleshooting
Safety: Unplug before working inside the reservoir.
- Reset sensor: Empty the reservoir completely, then refill to the MAX line. This can free a stuck float.
- Clean sensor: If your Salter model uses a float or probe, gently clean it with a soft cloth and mild detergent, then rinse.
- Tap to dislodge air: Gently tap the side of the unit near the sensor area to dislodge any trapped air bubbles.
- Check for tilt: Ensure the unit is level; tilting can cause the sensor to read incorrectly.
If the 'Add Water' indicator remains on despite correct level and cleaning, the water level sensor may need replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Water Level Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements