E14 error, abnormal ice size or shape, unit may stop with alarm

Safety first: Disconnect power before adjusting internal controls or cleaning the evaporator.

• Clean evaporator plate: Remove the ice bin and access the evaporator grid or plate. Use a Teka-approved descaler and soft brush to remove mineral deposits that affect ice release and thickness.
• Check thickness adjustment: Some models have a mechanical screw or electronic setting for ice thickness. Refer to the user manual and set it back to the factory default position.
• Inspect thickness sensor: Ensure the sensor or probe is firmly mounted and not bent. Clean its surface and check wiring for damage.
• Reset control: Perform a factory reset or calibration procedure if available in the service menu. This can recalibrate the thickness measurement.
• Test multiple cycles: Restore power and run several ice cycles, observing ice size and shape. Fine-tune the thickness setting if needed.