E15
Teka
EEPROM / Control Board Memory Error
E15 error, unit beeps and stops, often after power fluctuation
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board firmware, Voltage spike damage, Loose control board connectors, Defective main PCB
How to Fix / Troubleshooting
Safety first: Unplug the ice maker before touching the control electronics.
- Power reset: Leave the unit unplugged for at least 10 minutes to allow capacitors to discharge. Plug back in and see if the error clears.
- Check wiring: Remove the control board cover and inspect all connectors. Reseat each plug firmly to ensure good contact.
- Surge protection: If the error followed a power surge, consider using a surge protector to prevent future damage.
- Board replacement: If the error persists, the EEPROM or microcontroller on the main PCB is likely damaged. Replace the main control board with the correct Teka part number.
- Configuration: Some boards require configuration or parameter setting after replacement. Follow the service manual to set model-specific options.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements