Weasy
Internal Power Supply / Fuse Failure
Ice maker does not turn on at all, no lights or display, but outlet has power.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown internal fuse, Failed power supply section on PCB, Loose power cord connection inside chassis, Defective power switch module
How to Fix / Troubleshooting
Safety first: Unplug the Weasy ice maker before opening any covers. Capacitors on the board can hold charge; avoid touching bare solder joints.
- Confirm outlet power: Test with another appliance.
- Inspect power cord entry: Remove rear panel and verify the cord strain relief and connections to the main board are secure.
- Check internal fuse: Locate and test the fuse on the control board with a multimeter. Replace only with the same type and rating.
- If the new fuse blows immediately, there is likely a shorted component on the board; replacing the entire main control board is usually the practical repair.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board (Weasy Ice Maker PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements