E8 displayed; water pump may not circulate, and ice may not form on the evaporator plate.

Safety: Unplug the unit and close the water supply. Expect water spillage when hoses are removed.

• Access the pump: Remove the front lower panel or interior bin components to reach the circulation pump located near the water sump.
• Check for obstructions: Remove the pump inlet screen or filter and clean out debris, scale, or ice fragments. Flush the sump with warm water.
• Bleed airlock: Refill the sump and slightly tilt the unit if needed to help trapped air escape from the pump housing.
• Test the pump: With the pump electrically disconnected and the unit unplugged, measure motor winding resistance. An open circuit indicates a failed pump.
• Inspect wiring: Ensure the pump connector is fully seated and free of corrosion. Repair any damaged wires.
• Replace pump if necessary: If the motor is seized or electrically open, install a new Westinghouse-compatible circulation pump assembly and test for proper water flow during a cycle.