F6
Amana
Communication Error Between Control Boards
Microwave shows F6 and may be completely inoperative or behave erratically.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed main control board, Failed display/control interface board, Loose or damaged interconnect harness, Power surge damage to logic circuits
How to Fix / Troubleshooting
Safety First: Disconnect power before accessing internal components.
- Power cycle: Unplug the microwave for 10 minutes to fully discharge the control electronics, then reconnect and test.
- Inspect harness: Remove the control panel and inspect the wiring harness between the main control board and the user interface/display board. Look for loose connectors, corrosion, or pin damage.
- Reseat connectors: Carefully unplug and replug the multi-pin connectors between boards to ensure a solid connection.
- Check for burn marks: Visually inspect both boards for burned components or cracked solder joints.
- Board replacement: If F6 persists, one of the boards is likely defective. Replace the main control board first (most common). If the issue remains, replace the user interface board. This work is best done by a qualified technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements