F1
Avanti
Control Board Internal Error
Microwave beeps and displays F1; may not start or may stop mid-cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed microcontroller on PCB, Corrupted firmware, Shorted component on control board, Surge damage
How to Fix / Troubleshooting
Safety: Unplug the microwave before accessing the control panel.
Steps:
- 1. Power cycle: Unplug for 10 minutes, then plug back in. If F1 returns immediately, continue.
- 2. Inspect control board: Remove the control panel and visually inspect the PCB for burn marks, cracked solder joints, or damaged components.
- 3. Check for moisture: Look for signs of condensation or spills around the control area. Allow to dry thoroughly if moisture is present.
- 4. Replace control board: If no external cause is found and F1 persists, replace the main control board with the correct Avanti part.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements