Galanz Display / VFD / LED Module Failure

Microwave display is dim, flickering, or some segments are missing.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Aging VFD display, Loose display connector, Failing display driver on control board, Low-voltage supply issue

How to Fix / Troubleshooting

Safety: Unplug before removing the control panel.

Steps:

  • 1. Check brightness settings: Some models allow dimming. Ensure the display is not set to a low brightness mode.
  • 2. Reseat connectors: Remove the control panel and reseat the connector between the display module and control board.
  • 3. Inspect for damage: Look for corrosion or burnt components near the display driver area.
  • 4. Replace control panel or board: If the display remains dim or segments are missing, replace the display module or entire control board/control panel assembly as supplied by Galanz.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Display Module / Control Panel Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements