E10
Gorenje
Main Power Supply / Low Voltage Fault
Microwave shows E10 and all functions are disabled.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective low-voltage power supply on control PCB,Loose mains connector or terminal block,Burnt track or component on control board,Incorrect mains voltage supply
How to Fix / Troubleshooting
Safety: Unplug the microwave before removing any covers. Mains voltage is present on the input side.
- Check outlet: Verify the wall socket is delivering correct voltage using another appliance or a multimeter.
- Inspect power cord: Look for cuts, kinks, or burn marks on the Gorenje power cord. Replace if damaged.
- Internal inspection (qualified persons): Remove the cover and inspect the control PCB for burnt components, bulging capacitors, or discolored areas around the power supply section.
- Terminal block check: Ensure the mains input terminals are tight and not overheated. Tighten or replace as necessary.
- Board replacement: If the low-voltage section is damaged, replace the complete control PCB with the correct Gorenje spare.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements