E8
Gorenje
Convection Temperature Sensor / Overheat Fault
Microwave shows E8 and convection or grill functions do not operate correctly (on combination models).
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open or shorted convection temperature sensor,Overheated convection heater area due to blocked airflow,Failed thermal cut-out on convection heater,Faulty control PCB temperature circuit
How to Fix / Troubleshooting
Safety: Unplug the appliance and allow it to cool completely before inspection.
- Check for blocked airflow: Ensure that the rear and top vents are not obstructed. Remove any items stored on top of the microwave.
- Reset thermal cut-out (if manual reset type and accessible): Some models have a resettable thermostat on the convection heater housing. After cooling, press the reset button if present (qualified persons only).
- Inspect convection sensor: On combination models, locate the convection sensor near the fan/heater assembly. Check wiring and connector for heat damage.
- Sensor test: With the sensor disconnected and the unit unplugged, measure its resistance at room temperature. Replace if open/shorted or out of specification.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Convection Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements