E19
Hoover
Convection Heater or Fan Fault (Convection Models)
Microwave displays E19 and convection or combination modes fail to start or stop prematurely.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open convection heater element, Seized convection fan motor, Faulty convection thermostat, Wiring fault in convection circuit
How to Fix / Troubleshooting
Safety first: Unplug the microwave and allow it to cool.
User-level checks:
- Try microwave-only mode; if it works but convection fails with E19, the issue is isolated to the convection system.
- Listen for the convection fan when starting a convection cycle; absence of airflow noise suggests a fan issue.
Technician-level checks:
- Access the rear or side panel to reach the convection heater and fan assembly.
- Test the heater element for continuity; replace if open.
- Spin the convection fan by hand; if stiff or noisy, replace the fan motor.
- Check the convection thermostat or thermal cut-out for continuity.
- Inspect wiring and connectors for heat damage.
Note: Convection components run at high temperatures; ensure all thermal protections are intact after repair.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Convection Heater Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements