E11
Ikea Convection Heater or Fan Circuit Fault

Microwave shows E11 and convection (hot air) mode does not heat, though fan may run.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Open convection heating element, Failed convection fan motor, Faulty convection thermostat, Burned wiring to convection assembly

How to Fix / Troubleshooting

Safety: Unplug the appliance and let it cool before working near the convection heater.

Steps:

  • 1. Test convection mode: Set the microwave to convection-only mode and a moderate temperature. If the fan runs but no heat is produced and E11 appears, suspect the heater or thermostat.
  • 2. Listen for fan: If the fan does not run, the convection fan motor or its wiring may be faulty.
  • 3. Access rear panel (DIYers): Remove the outer cover and rear panel to access the convection heater and fan assembly.
  • 4. Continuity tests: Use a multimeter to test the convection element and thermostat for continuity. Check the fan motor windings as well.

Resolution: Replace the failed convection heater, fan motor, or thermostat with the correct IKEA-compatible parts.

Advertisements

Repair Difficulty

Hard 4/5

Required Part

Convection Heating Element
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements