Safety first: Unplug the appliance before removing any covers.

Step 1 – Check mains supply: Verify the wall socket is delivering stable voltage and that the plug is fully inserted. Try another known‑good outlet.
Step 2 – Power cycle: Disconnect power for 10–15 minutes, then reconnect and observe the display. If F07 reappears immediately, the fault is likely internal.
Step 3 – Inspect control board (advanced): Remove the outer cabinet and access the main PCB. Look for bulging capacitors, burnt components, or cracked solder joints near the low‑voltage section (small transformer or switching PSU).
Step 4 – Check display connector: Ensure the connector between the display module and main PCB is firmly seated and free of corrosion.
Step 5 – Replace faulty module: If no obvious repairable damage is found, replace the main control board or display module as specified by Indesit for your model.

Note: Component‑level repair of the PCB should only be attempted by experienced electronics technicians.

Microwave display shows F07 and the clock or timer cannot be set; sometimes the display is blank or flickering.

Possible Causes