Morphy Richards Display / VFD or LED Module Degradation

Microwave display is dim, flickering, or some segments are missing.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Aging VFD display, Poor solder joints on display pins, Low-voltage supply issue, Damaged display ribbon cable

Steps:

1. Check brightness setting: Some models allow adjusting display brightness. Refer to the user manual.
2. Power reset: Unplug for 5 minutes and reconnect to rule out a temporary glitch.
3. Inspect control panel (for competent persons): Remove the panel and check for cracked solder joints on the display module. Reflow if skilled.

If the display remains dim or segments are permanently missing, the display module or entire control PCB may need replacement.

Medium 3/5

Display Module / Control PCB

Check Price on Amazon

We may earn a commission from links on this page.