Teka Convection Heating Element Failure

Microwave convection (hot air) mode does not heat, but fan runs and microwave mode works.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Open convection element,Blown thermal cut-out on convection circuit,Loose wiring to convection heater,Defective convection relay on PCB

How to Fix / Troubleshooting

User checks:

  • Confirm that the fan runs but no heat is produced in convection mode.
  • Allow sufficient preheat time and verify with an oven thermometer if available.

Technician steps:

  • Access the convection heater at the rear of the cavity.
  • Test the element and thermal cut-out for continuity.
  • Repair or replace the element or cut-out as needed.
Advertisements

Repair Difficulty

Hard 4/5

Required Part

Convection Heating Element
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements