F1E4
Whirlpool
Inverter Board Failure (Inverter Models)
Microwave displays F1E4 and will not heat
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed inverter power board, Shorted magnetron drawing excessive current, Loose inverter wiring connections
How to Fix / Troubleshooting
Critical safety warning: Inverter-based microwaves contain extremely high voltages even when unplugged. Do not attempt inverter or magnetron testing unless you are trained and equipped. Serious injury or death can result.
- Power reset: Unplug the unit for 10 minutes, then reconnect and test. If F1E4 returns, internal components are likely faulty.
- Basic inspection only: With power disconnected, remove the outer cabinet and visually inspect the inverter board for burnt components or loose connectors. Do not touch the high-voltage side.
- Check cooling: Ensure the cooling fan and air passages are not blocked; overheating can stress the inverter.
- Professional service recommended: In most cases, the inverter board and/or magnetron must be tested and replaced by a qualified technician using proper high-voltage safety procedures.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Inverter Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements