AEG Keep Warm Control / Sensor Placement Issue

Keep Warm function turns off too soon or does not keep food warm enough.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Loose bottom sensor, Poor pot contact, Firmware logic issue, Weak low-power heater drive

Safety first: Unplug and cool the cooker before internal inspection.

Check pot seating: Ensure the inner pot is fully seated and not lifted by debris or a warped base.
Inspect bottom sensor mount: From the underside, verify that the bottom NTC sensor is firmly attached to the heating plate and has good thermal contact.
Factory reset: Perform a reset to restore default Keep Warm behavior if supported.
Sensor replacement: If the sensor is loose or damaged, replace it to restore accurate temperature control.

Medium 3/5

Bottom Temperature Sensor (NTC)

Check Price on Amazon

We may earn a commission from links on this page.