P0
Gorenje
Pressure Sensor Zero / No Pressure Detected
Display shows P0 or similar and cooker does not build pressure; program may cancel.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Pressure sensor out of calibration, Loose pressure sensor hose, Faulty pressure sensor, Control board error
How to Fix / Troubleshooting
Safety: Work only on a cold, depressurized cooker.
- Check sensor hose: Locate the small silicone hose between the lid/top chamber and the pressure sensor. Ensure it is firmly attached at both ends and not cracked.
- Inspect for blockages: Remove the hose and blow through it to confirm it is clear. Clean any blockage.
- Reseat sensor connector: On the PCB, unplug and replug the pressure sensor connector to ensure good contact.
- Test with water: After reassembly, run a short pressure program with water. If P0 persists and there is no mechanical leak, replace the pressure sensor module.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Pressure Sensor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements