Err
Kenmore
General Control System Fault
Display shows 'Err' or 'Error' and beeps; no specific numeric code is given.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Firmware glitch, Stuck keypad button, Moisture in control panel, Failing main control board
How to Fix / Troubleshooting
Safety first: Unplug the multicooker before cleaning the control panel.
- Power cycle: Unplug the unit for at least 10 minutes to allow capacitors to discharge, then plug back in and test.
- Dry the panel: If there was a recent spill or steam exposure, leave the cooker unplugged in a dry, warm area for several hours to allow moisture to evaporate.
- Clean keypad: Wipe the control panel with a slightly damp cloth, then dry thoroughly. Ensure no buttons are physically stuck or jammed.
- Test each button: Plug in and press each button individually to see if any are unresponsive or trigger Err. A stuck or shorted keypad may require replacement.
If Err persists with a dry, clean panel, the main control board or keypad membrane is likely defective and should be replaced.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements