E14
Lagostina
Firmware / Internal Memory Fault
E14 error appears immediately after powering on; cooker does not allow any program selection.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted firmware in microcontroller, Failed EEPROM storing configuration, Power surge damage to logic circuits, Incomplete factory programming
How to Fix / Troubleshooting
Safety first: Unplug the multicooker before any inspection.
- Power cycle: Unplug for 10 minutes, then plug back in and observe if the error clears.
- Check for signs of surge: Inspect the control board for burn marks or damaged components, especially near the low-voltage regulator.
- Factory reset (if available): Consult the Lagostina manual for any key combination that restores factory settings and attempt it.
Firmware or memory faults generally cannot be repaired at home; the main control board must be replaced or reprogrammed by an authorized service center.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements