E5 error appears immediately when selecting a pressure program; cooker does not attempt to heat.

Safety: Unplug the multicooker before opening any covers. Do not operate with the lid disassembled.

• Inspect lid connection: On models with a removable lid harness, check the multi-pin connector where the lid wiring plugs into the body. Ensure it is fully seated and free of corrosion.
• Check flex cable: If your Salton model uses a flexible ribbon or cable between lid and body, inspect for kinks, cuts, or broken conductors. Replace if visibly damaged.
• Access the pressure sensor: Remove the inner lid panel (screws on the underside of the lid) to locate the small pressure sensor module, usually near the steam path. Confirm its connector is firmly attached.
• Re-seat connectors: Unplug and replug the sensor connector to improve contact. Do not pull on the wires; grip the plastic housing.

If E5 remains after verifying wiring, the pressure sensor or main PCB is likely defective. Replacement of these components is best handled by a qualified technician due to calibration and sealing requirements.