Programs end too quickly; cooker beeps and switches to keep-warm after only a few minutes without fully cooking food.

Safety: Ensure adequate liquid is used to avoid dry heating.

• 1. Check recipe and fill level: Confirm you are using enough water as per Toshiba instructions for the selected program.
• 2. Clean sensors and heater: Remove residue from heater plate and ensure sensors are clean and firmly attached.
• 3. Sensor replacement: If premature termination occurs across multiple programs, replace the bottom NTC and, for pressure programs, the pressure sensor module.
• 4. Test with water: Run a standard rice or pressure program with only water and observe if the full cycle completes.

If the issue persists after hardware checks, main PCB replacement may be necessary.