F1E2
Amana
EOC configuration or software mismatch
Oven displays F1E2; may occur after replacing the control board.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect EOC part installed, Control not programmed for this model, Firmware mismatch between display and power board
How to Fix / Troubleshooting
Safety first: Turn off power before accessing the control area.
Step-by-step checks:
- Verify control part number: Confirm that the EOC installed is the correct Amana part for your exact model number.
- Check tech sheet: Locate the tech sheet (usually in a plastic pouch behind the control panel or under the cooktop). Follow any configuration or calibration steps required after control replacement.
- Re-seat connectors: Ensure all display and power board connectors are fully seated and not cross-connected.
- Replace with correct board: If the wrong control was installed or configuration fails, replace with the correct EOC.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Electronic Oven Control Board (EOC)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements