Amana
Broil element circuit failure
Oven does not heat in broil mode, but bake may still work.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open broil heating element, Burned wire at broil element terminal, Failed broil relay on EOC, Loose connection at terminal block
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker and allow the oven to cool.
Step-by-step checks:
- Inspect broil element: Look at the top element for breaks, blisters, or sagging. Replace if damaged.
- Test resistance: Access the broil element terminals from the rear or by removing mounting screws inside the cavity. Disconnect wires and measure resistance (typically 15–40 Ω). Replace if open.
- Check wiring: Inspect terminals and wires for heat damage. Repair as needed.
- Control board: If the element and wiring are good but no power is delivered in broil mode, the broil relay on the EOC may have failed and the board should be replaced.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements