F14
Asko
Display Module / UI Power Fault
Oven display shows F14, touch display may be blank or frozen.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed display module, Open low-voltage supply from main control, Loose display ribbon cable, Shorted LED backlight circuit
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker before removing the control panel.
- Access display module: Remove the screws securing the front control panel and gently pull it forward to expose the display PCB and ribbon cables.
- Check connections: Ensure all ribbon cables and connectors between the display and main control are fully seated. Reseat them to clear any poor contact.
- Inspect for damage: Look for burn marks, cracked components, or moisture damage on the display board. Replace the display module if damaged.
- Verify low-voltage supply: With power restored and using proper safety precautions, a technician can measure the low-voltage output from the main control to the display (often 5 V or 12 V DC). If missing, the main control board is likely faulty.
- Replace faulty module: Install a new display module or main control board as indicated by testing, then reassemble and test operation.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Display / User Interface Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements