E0
Avanti
Configuration or Calibration Error
Display shows E0 and oven controls are unresponsive or partially functional.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Control board not configured for model, Corrupted EEPROM on EOC, Recent replacement EOC not programmed, Power interruption during setup
How to Fix / Troubleshooting
Safety first: Disconnect power before removing the control panel.
- Check user manual: Some Avanti models require a configuration code to be entered after replacing the control. Refer to the tech sheet (often behind the rear panel) for model‑specific programming steps.
- Power reset: Turn off the breaker for 5–10 minutes, then restore power and see if the error clears.
- Verify wiring: Ensure all connectors are fully seated on the EOC and that no pins are bent.
- Reprogram or replace: If the E0 code persists and programming steps fail, the EOC memory may be corrupted. Replace the electronic oven control (EOC) with the correct part number for your Avanti model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control (EOC)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements