Beko oven display shows E05 and the cooling fan or oven fan does not run when a function is selected.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Isolate the oven from mains power before removing any panels. Fan blades can be sharp.
Check fan operation:
- With power disconnected, remove the rear panel inside the oven cavity to access the convection (fan) motor and blade.
- Try to spin the fan blade by hand. It should rotate freely without grinding. If stiff or seized, the motor is likely faulty.
- Inspect wiring to the fan motor for burns or loose connectors.
- For the cooling fan (usually on top of the oven cavity), remove the top cover and visually inspect the fan and wiring.
- Reconnect power briefly and start a fan-assisted function while observing (from a safe distance) whether the fan attempts to start. Immediately disconnect power after testing.
- If the fan hums but does not turn, the motor is likely defective. Replace the affected fan motor assembly.
- If both motors test good, the fan relay or control board may be faulty and require replacement.
Warning: Never put your hands near a powered fan. Always disconnect power before touching or removing fan assemblies.
Repair Difficulty
Required Part
We may earn a commission from links on this page.