E08
Beko
Fan Element (Ring Element) Circuit Fault
Beko oven displays E08 and the fan-assisted heating function does not work; fan may run but no heat.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open-circuit fan (ring) heating element, Burnt terminals on fan element, Wiring harness damage to fan element, Faulty fan element relay on PCB
How to Fix / Troubleshooting
Safety first: Disconnect power at the mains. Allow the oven to cool fully.
Check the fan element:
- Remove the rear panel inside the oven cavity to expose the circular fan element around the fan motor.
- Visually inspect the element for cracks, hot spots, or breaks.
- Disconnect the element terminals and measure resistance with a multimeter. A typical reading is 20–40 Ω; OL indicates failure.
- Inspect the wiring and connectors for signs of overheating or looseness.
- Replace the fan element if it is open or damaged, ensuring correct routing of wires away from moving fan blades.
- If the element and wiring are good, the control board relay or triac controlling the fan element may be defective and require replacement.
Warning: Do not bend or sharply twist the new element during installation; this can cause premature failure.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Fan Oven Heating Element (Ring Element)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements