E04
Blomberg
Main Control Board Communication / Internal Error
Display shows E04 and oven functions are disabled; may occur after a power surge or during high-temperature use.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board firmware, internal PCB failure, power surge damage, loose low-voltage harness connections
How to Fix / Troubleshooting
Safety first: Switch off the oven at the breaker before accessing the control panel.
- Power reset: Turn off power for at least 10–15 minutes to allow capacitors to discharge. Restore power and check if E04 clears.
- Check wiring to control panel: Remove the top panel or front control panel screws to access the main PCB and display module. Inspect ribbon cables and connectors for looseness or corrosion. Reseat all connectors firmly.
- Look for visible damage: Examine the PCB for burn marks, swollen capacitors, or cracked solder joints. Any visible damage usually means the board must be replaced.
- Surge protection: If the error appeared after a storm or outage, consider installing a surge protector on the oven circuit after repair.
- Replace PCB if needed: If wiring is sound and the error persists after reset, replace the main control board. This may require programming specific to your Blomberg model, so professional service is recommended.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board (Oven PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements