Oven door will not lock during self-clean; self-clean cycle will not start.

Safety First: Turn off power at the breaker before accessing the lock assembly.

• Check for obstructions: Inspect the latch area for debris or buildup that could block movement. Clean as needed.
• Verify door alignment: Ensure the door closes evenly and the latch strike lines up with the lock mechanism. Adjust hinges if necessary.
• Access lock motor: Remove the top panel or rear cover to reach the door lock motor and latch assembly. Check for broken plastic parts or disconnected rods.
• Test motor: With power restored and caution, start a self-clean cycle and listen for the motor. If it does not run, test for voltage at the motor and replace the assembly if the motor is open or seized.