Oven will not heat in bake mode; display and lights work but temperature does not rise or only broil element glows.

Safety First: Turn off power at the breaker and verify the oven is cold before touching elements.

• Visual inspection: Remove oven racks and inspect the bake element at the bottom of the cavity. Look for blisters, cracks, or burn-through spots.
• Continuity test: Remove the rear panel, disconnect the bake element wires, and test the element with a multimeter. It should show continuity (typically 15–40 Ω). Replace if open.
• Check terminals: Inspect element terminals and wires for burns or loose connections. Repair or replace damaged wiring with high-temperature oven wire.
• Control relay: If the element and wiring are good but no voltage is supplied during bake, the bake relay on the main control (EOC) may be defective and require board replacement.