E0
Danby
Control Configuration or EEPROM Error
Display shows E0 and oven controls may be disabled or limited.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted control board memory, Incorrect configuration after power surge, Failed electronic oven control
How to Fix / Troubleshooting
Safety First: Disconnect power before removing the control panel.
- Power cycle: Turn off the breaker for 5–10 minutes, then restore power. Sometimes this clears a temporary configuration error.
- Check model configuration: Some Danby control boards require configuration codes to match the oven model. If the board was recently replaced, verify that the correct configuration procedure was followed (refer to service documentation).
- Inspect control board: Remove the control panel and visually inspect the board for burnt components or corrosion. Any visible damage indicates replacement is needed.
- Replace control board: If E0 persists and wiring is intact, replace the electronic oven control with the correct Danby part number for your model.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements