Electrolux
No heat due to open heating circuit
Oven will not heat at all, no error code displayed, control panel appears normal
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Tripped house breaker or blown internal thermal fuse, Open bake and/or broil element, Loose or burnt wire at terminal block, Failed EOC relay output
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker before removing panels. Verify power with a meter if you are qualified.
- Check power supply: Confirm the range/oven breaker is fully on and not partially tripped. Reset if needed. Verify correct voltage at the outlet or junction box.
- Inspect terminal block: Remove the rear cover and inspect the terminal block where the power cord connects. Tighten loose screws and replace any burnt terminals or wires.
- Test elements: Disconnect and measure resistance of the bake and broil elements. Replace any that are open or visibly cracked/blistered.
- Check thermal fuse/high-limit: Locate any thermal fuse or high-limit thermostat on the rear or top of the oven cavity. Test for continuity and replace if open.
- Control board: If power, elements, and fuses are good, the EOC may not be sending power to the elements. Replace the EOC.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements