Oven displays F30 and will not heat or shuts off shortly after starting.

Safety First: Turn off power at the breaker before accessing the sensor or control.

• Check sensor connection:
  • Locate the oven temperature sensor probe inside the oven cavity (back wall).
  • Remove the two screws and gently pull the sensor forward to access the connector.
  • Ensure the connector is fully seated; inspect for burnt or loose pins.
• Test sensor resistance:
  • Disconnect the sensor and measure resistance at room temperature.
  • A good Frigidaire RTD should read ~1050–1100 Ω at 70°F (21°C).
  • If the meter shows OL (open) or extremely high resistance, replace the Oven Temperature Sensor (RTD).
• Check harness to EOC:
  • If the sensor tests good, trace the harness from the sensor to the EOC.
  • Look for breaks, pinched sections, or burnt insulation.
  • Repair or replace the Oven Sensor Harness if damaged.