E030
Gaggenau
Touch panel calibration / sensor fault
Oven shows E030 and does not respond to some or all touch inputs
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Mis-calibrated capacitive touch sensors, Moisture or condensation on glass panel, Damaged touch sensor foil, Faulty UI electronics
How to Fix / Troubleshooting
Safety: Turn off power before removing the control panel.
- Clean glass: Wipe the control glass with a dry, lint-free cloth to remove moisture, grease, or cleaning residues.
- Dry out: Leave the oven door open and allow the control area to dry for several hours if condensation is suspected.
- Power cycle: Turn off the breaker for 10 minutes to force a recalibration of the touch sensors on restart.
- Check mounting: Ensure the glass panel is not under mechanical stress (e.g. twisted or overtightened screws) which can affect sensor operation.
Note: If E030 persists, the touch sensor foil or UI board may be defective and require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Touch Sensor Panel / UI Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements