GE Profile
Door lock mechanism stuck closed
Oven door will not open after self-clean cycle has completed and oven is cool.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Warped lock latch from high heat, Failed lock motor, Misaligned lock linkage, Faulty lock switch feedback
How to Fix / Troubleshooting
Safety first: Turn off power at the breaker and allow the oven to cool completely.
- Wait and reset: Sometimes the lock will release after additional cooling. After 30–60 minutes, restore power and press Clear/Off.
- Force unlock via control: Start a self-clean cycle, wait 30 seconds, then cancel it to trigger an unlock sequence.
- Manual release: If still locked, remove the top or rear panel to access the lock assembly and manually move the latch to the open position with power off.
- Replace lock assembly: If the mechanism is warped or the motor does not run, replace the door lock motor assembly.
Warning: Do not pry the door open from the front; this can crack the glass and damage the frame.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Oven Door Lock Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements