Hoover oven shows E06 and the display or touch controls may be unresponsive or erratic.

Safety first: Isolate the oven from the mains before removing the control panel.

• Power reset: Turn off power for 5–10 minutes, then restore. If E06 returns immediately, proceed.
• Access control panel:
  • Remove the oven from the cabinet if necessary.
  • Unscrew and carefully remove the front control fascia.
  • Locate the ribbon cable(s) between the touch panel/display PCB and the main control board.
• Inspect and reseat connectors:
  • Disconnect the ribbon cable, inspect for corrosion, burning, or cracked tracks.
  • Clean contacts gently with isopropyl alcohol if contaminated.
  • Reconnect firmly, ensuring the cable is fully seated and not twisted.
• Check for moisture damage:
  • Look for signs of steam or liquid ingress behind the glass fascia.
  • If the touch panel membrane is bubbled or delaminated, it may need replacement.
• Component replacement:
  • If reseating cables does not resolve the issue, replace the user interface PCB or complete control panel assembly with a Hoover-specified part.
  • If the problem persists even with a new UI, the main control board may be defective and should be replaced by a professional.