F0E1
Ikea
Calibration or sensor configuration error
F0E1 displayed; oven may not recognize temperature or cooking mode correctly
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect oven sensor type configured, Control board not calibrated, Replacement sensor incompatible with model, Faulty control firmware
How to Fix / Troubleshooting
Safety first: Turn off power before accessing internal components.
- Verify sensor part: Check that any recently replaced oven temperature sensor matches the original Ikea/Whirlpool part number for your model.
- Run calibration (if available): Some models allow temperature calibration through the user menu. Follow the user manual to perform a calibration reset.
- Check wiring: Inspect the sensor harness and connectors for damage or poor contact.
- Control board replacement: If the correct sensor is installed and wiring is good, the control board may have a configuration or firmware fault and should be replaced.
Tip: Always cross-reference part numbers using the full Ikea model and service number from the rating plate.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Oven Temperature Sensor (NTC Probe)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements