F0E2
Ikea
Convection fan or speed feedback fault
F0E2 displayed; fan-assisted or convection modes may not work correctly
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed convection fan motor, Blocked fan blades, Faulty fan speed sensor (if equipped), Wiring issue between fan and control
How to Fix / Troubleshooting
Safety first: Disconnect power and allow the oven to cool before removing the rear panel or fan cover.
- Check fan operation: Start a convection mode and listen for the fan. If silent or noisy, suspect a fan issue.
- Inspect fan blades: Remove the fan cover inside the oven cavity and check for food debris or grease buildup on the blades. Clean thoroughly.
- Access fan motor: From the rear of the oven, locate the convection fan motor. Check wiring connections and look for signs of overheating.
- Test motor: Measure motor winding resistance. An open circuit indicates a failed motor. Replace the convection fan motor if defective.
- Check speed sensor (if present): Some models have a tachometer or Hall sensor. Inspect and reseat its connector; replace if damaged.
Note: After replacing the fan motor, verify that convection modes run quietly and that F0E2 does not reappear.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Convection Fan Motor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements