Ikea
No power / dead control
Oven display and controls completely dead; no lights or response
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Tripped household breaker, Loose connection at terminal block, Blown internal fuse, Failed power supply on control board
How to Fix / Troubleshooting
Safety first: Verify the breaker is off before opening any covers.
- Check household breaker: Ensure the oven's circuit breaker has not tripped. Reset if necessary and observe if it trips again.
- Inspect terminal block: Remove the rear cover and check that the supply wires are firmly attached and not burnt.
- Internal fuse: Some Ikea ovens have an internal fuse on the control board or wiring harness. Test and replace with the exact same rating if blown.
- Control power supply: If mains power is present at the board but it remains dead, the low-voltage power supply on the board has likely failed. Replace the control board.
Warning: Never bypass fuses or operate with damaged wiring.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Control Board or Internal Fuse
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements