Broil function does not work; other modes heat normally.

Safety first: Disconnect power before accessing the broil element or control components.

• 1. Inspect broil element: Open the oven door and visually inspect the upper broil element for breaks, blisters, or burn marks.
• 2. Test continuity: Remove the rear panel to access the broil element terminals. Disconnect the wires and measure resistance across the element. An open reading indicates a failed element that must be replaced.
• 3. Check wiring: Ensure the broil element connectors are tight and not heat-damaged. Repair or replace any burnt wiring.
• 4. Control output: If the element is good, test for voltage at the element terminals when broil is selected (use extreme caution or have a professional perform this). If no voltage is present, the broil relay or selector switch may be defective and require replacement.