Liebherr Convection Mode Heating Failure

Oven fan runs but there is no heat in convection or fan-assisted modes.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed ring (convection) heating element, Loose wiring to convection element, Faulty convection relay on control board, Mode selector fault

Safety first: Disconnect mains power before removing panels.

Steps:

Remove the internal rear panel to access the ring heating element around the convection fan.
Inspect the element for visible damage or breaks.
Disconnect one terminal and measure resistance; an open circuit means the element must be replaced.
Check wiring from the element to the control board for secure connections.
If the element and wiring are good, the convection heating relay or mode selection circuit on the control board may be defective.

Medium 3/5

Convection (Ring) Heating Element

Check Price on Amazon

We may earn a commission from links on this page.