E10
Logik
Fan Oven Element Fault
Logik oven shows E10 and the fan runs but there is no heat in fan-assisted modes.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open-circuit fan oven element, Loose connection at fan element terminals, Burnt wiring to fan element, Faulty fan element relay on PCB
How to Fix / Troubleshooting
Safety first: Isolate the oven from mains power. Allow the oven to cool before removing the internal rear panel.
- Confirm symptom: In fan oven mode (before isolating), check that the fan runs but the oven does not heat. This points to the fan element.
- Access fan element: Remove the screws holding the internal rear cover inside the oven cavity. Behind it you will see the circular fan element around the fan.
- Visual check: Inspect the element ring for cracks, burn spots, or breaks.
- Test with multimeter: Disconnect the element terminals from the rear of the oven (you may need to remove the rear outer panel). Measure resistance; infinite resistance means the element is faulty and must be replaced.
- Check terminals and wiring: Tighten any loose spade connectors and replace any that are discolored or heat-damaged. Ensure wires are not touching the fan blades.
- Replace element: Fit a new Logik-compatible circular fan oven element, secure it with screws, and reconnect wiring firmly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Fan Oven Element (Circular Element)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements