F1E0
Maytag
Internal EOC failure
F1E0 error, oven display shows error shortly after power-up
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Defective control board, power surge, internal memory error, overheated control
How to Fix / Troubleshooting
Safety First: Disconnect power before accessing the control.
- Power cycle: Turn breaker OFF for 5 minutes, then ON. If F1E0 reappears immediately, the control is likely bad.
- Check for overheating: Ensure insulation or wiring is not blocking airflow around the control housing.
- Inspect board: Remove the control and inspect for burnt components or corrosion.
- Replace control: Install a new EOC using the exact part number for your Maytag oven. Transfer wires one at a time to avoid miswiring.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Oven Control Board (EOC)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements