Morphy Richards
Convection (Fan) Element Failure
Morphy Richards oven fan runs but there is no heat in fan-assisted mode; grill and conventional modes may still work.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Open-circuit fan element, Burnt fan element terminals, Wiring fault to fan element, Faulty fan-oven relay on control board
How to Fix / Troubleshooting
Safety first: Isolate the oven from mains before accessing the rear panel.
Steps:
- Access fan element: Remove the inner rear panel of the oven cavity to expose the circular fan element.
- Visual check: Look for cracks, breaks, or burn marks on the element ring.
- Continuity test: Disconnect the element terminals from the rear and measure resistance. An open reading indicates failure.
- Replace element: Remove mounting screws and fit a new fan oven element specific to your Morphy Richards model.
- Control check: If the element is good but not powered, test the fan-oven relay on the electronic control board.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Fan Oven Element
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements