F06
New World
User Interface / Keypad Communication Fault
Display shows F06 and oven controls are unresponsive or erratic.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose ribbon cable between touch control and main PCB, failed touch control panel, liquid ingress into control fascia, faulty main control PCB
How to Fix / Troubleshooting
Safety first: Disconnect the oven from mains before removing the control panel.
- Power reset: Turn off power for 10 minutes, then restore. If F06 returns immediately, proceed.
- Inspect fascia and buttons: Check for signs of moisture, steam damage, or cleaning fluid ingress around the display and buttons. Allow to dry fully if recently cleaned.
- Check ribbon cable: Remove the front control panel (usually a few screws from inside the door area). Locate the flat ribbon cable from the keypad/touch board to the main PCB. Reseat both ends carefully, ensuring they are fully inserted and locked.
- Examine for corrosion: Look for green/white corrosion on connectors or tracks. If present on the keypad board, replace the user interface/touch control module.
- Main PCB replacement: If the keypad board appears fine and reseating cables does not help, the main control PCB may be defective and require replacement by a qualified technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Oven Touch Control / User Interface PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements