Oven shows E10 and fan-assisted modes do not heat properly; fan may run but temperature stays low.
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Possible Causes
How to Fix / Troubleshooting
Safety first: Disconnect power and allow the oven to cool before removing the inner rear panel.
- Remove fan cover: Inside the cavity, remove screws holding the rear cover to expose the convection fan and surrounding element.
- Inspect element: Look for cracks or burn marks on the circular element around the fan.
- Test resistance: Disconnect the element leads and measure resistance. An open reading means the element is faulty.
- Check wiring: Ensure the wires to the element are secure and not heat-damaged.
Replace the convection element if open or damaged. If the element is good but E10 persists, the control board relay may be defective and require replacement.
Repair Difficulty
Required Part
We may earn a commission from links on this page.