F10
Proline
Electronic Clock / Timer Failure
Clock cannot be set or resets randomly, oven will not start and F10 is displayed
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Internal fault in clock module, Power supply instability on timer board, Loose connectors to timer, Shorted components on timer PCB
How to Fix / Troubleshooting
Safety first: Disconnect mains power before accessing the control area.
- Reset attempt: Restore power and attempt a full clock reset according to the Proline user manual. If F10 reappears immediately, proceed with hardware checks.
- Access timer module: Remove the control panel to expose the clock/timer PCB.
- Check wiring: Verify that all connectors to the timer are secure and that there are no burnt or loose wires.
- Inspect PCB: Look for burnt components, cracked solder joints, or bulging capacitors. If present, the timer module should be replaced.
- Module replacement: Replace the clock/timer assembly with the correct Proline part number. Transfer wiring one connector at a time.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Electronic Clock / Timer Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements