RCA
Open Broil Heating Element Circuit
RCA oven will not heat in broil mode, but bake works normally; no error code displayed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Burned-out broil element, Loose broil element connections, Broken broil circuit wiring, Failed broil relay on control board
How to Fix / Troubleshooting
Safety first: Shut off power at the breaker before servicing.
- Inspect broil element: Look at the upper broil element for cracks, breaks, or burn marks.
- Test continuity: Access the broil element terminals from the rear or by removing mounting screws inside the oven. Disconnect wires and test with a multimeter; replace the element if open.
- Check wiring: Inspect wires and terminals for heat damage or loose connections. Repair or replace as needed.
- Control board diagnosis: If the broil element and wiring are intact, the broil relay on the electronic oven control board may be defective and require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Advertisements