Sauter Stuck Heating Relay or Selector Contact

Oven continues heating after it has been switched off at the controls

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Welded relay contacts on control board, Selector switch contacts fused closed, Incorrect wiring after previous repair

How to Fix / Troubleshooting

Safety first: Immediately switch off the oven at the circuit breaker to stop heating. Do not use the oven until repaired.

  • Inspect control board: Disconnect power, remove the control panel, and examine the relays for signs of overheating or melting. Replace the control board if a relay is welded closed.
  • Check selector switch: Test continuity across the switch contacts with the knob in the off position. Replace the switch if it still passes power.
  • Verify wiring: Compare wiring to the Sauter schematic to ensure no wires are incorrectly bridged.
  • Test after repair: Restore power and confirm that all heating stops when the oven is turned off.
Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Electronic Control Board
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements